To Next PageTo Next PageWhat to do if my Napa 85-435 Battery Charger will not turn on when properly connected?
If your Napa Battery Charger isn't turning on despite being properly connected, the issue likely lies with the AC outlet or a poor electrical connection. Check for an open fuse or circuit breaker supplying the AC outlet. Also, inspect the power cord and extension cord for any loose connections.
What to do if my Napa 85-435 Battery Charger is on but not charging?
If your Napa Battery Charger is on but not charging the battery, it's likely due to poor clip connections. Check for a poor connection at the battery and frame, ensuring the connecting points are clean. Rock the clips back and forth to improve the connection.
Why is my Napa 85-435 making a clicking sound?
An audible clicking sound from your Napa Battery Charger can stem from several issues. It could be due to the circuit breaker cycling because of a defective battery, shorted battery cables or clips, a severely discharged battery, or reverse connections at the battery. To resolve this: * Ensure the charger settings are correct. * Have the battery checked for defects. * Inspect and replace any shorted cables or clips. * Allow charging to continue, as the battery might recover sufficiently to take a charge. If it persists for more than 20 minutes, have the battery checked. * Correct any reversed lead connections after shutting off the charger.
General| Voltage | 12V |
|---|---|
| Input Voltage | 120V AC |
| Output Voltage | 12V DC |
| Type | Automatic |
| Safety Features | Overcharge protection, Short circuit protection |
Warning about explosive gases generated by lead-acid batteries during normal operation.
Precautions for handling battery acid, including eye protection and immediate washing.
Ensuring the charging area is well-ventilated and battery terminals are clean before charging.
Guidelines for locating the charger away from the battery to prevent corrosion and ensure ventilation.
Steps for safely connecting and disconnecting charger clips to the battery and chassis.
Positioning AC/DC cables to avoid damage and staying clear of moving engine parts.
Checking battery post polarity and grounding for correct connection in vehicles.
Detailed steps for connecting to a battery removed from a vehicle, including cable extensions.
Recommended AWG wire size for extension cords based on AC input rating and length.
Overview of charger features like selector switches, LEDs, and power indicators.
Instructions for using cable holders for convenient storage of charger cables.
Explanation of the functions of the control panel switches and LEDs.
Guide to selecting the correct battery type (Regular, Deep-Cycle, AGM, GEL) for charging.
Instructions for selecting charge rates (2A, 10A, 55A) based on battery needs.
Description of automatic charging, completion, and maintain modes for optimal battery charging.
Step-by-step guide for using the engine start feature to jump-start a vehicle.
Explanation of Cold Cranking Amps (CCA) and its importance for battery performance.
Table correlating battery size/rating (AH, CCA, RC) with estimated charging times at 2A and 10A rates.
Instructions for cleaning the charger and noting that it has no user-serviceable parts.
Guidelines for storing the charger unplugged in a cool, dry place and handling clips correctly.
Table detailing common issues like clicking sounds, humming, and no-start cycles with their causes and solutions.
Steps to take before returning the charger for service, including checking connections and battery health.
Details of the limited warranty, coverage, exclusions, and duration for the battery charger.
Further details on warranty terms, manufacturer obligations, and disclaimers.
