What to do if Napa Carlyle Tools 791-7100B Jacks unit will not lift to full height?
If your Napa Jacks unit isn't lifting its full height, it might have air trapped in the hydraulic system. Try removing the air by following the procedure described in the SETUP section of the manual.
Why Napa Carlyle Tools 791-7100B Jacks unit will not lift rated load?
If your Napa Jacks unit is unable to lift the rated load, the most likely cause is air trapped in the hydraulic system. You should purge the air from the hydraulic system by following the procedure detailed under SETUP.
What to do if Napa Carlyle Tools 791-7100B unit feels spongy?
If your Napa Jacks unit won't hold the rated load or feels spongy, it could be due to air in the hydraulic system. You'll want to purge the air from the hydraulic system, using the procedure described in the SETUP section.
Crucial safety advice: read manual thoroughly before using the device.
Discusses inherent hazards of lifting devices and need for user care.
Lists essential steps and precautions to prevent accidents during operation.
Highlights risks of injury or damage from ignoring safety instructions.
Procedure to remove trapped air from the hydraulic pump for proper function.
To Next Page
General