SYSTEM TROUBLE LEDs will flash.
6. The keypad will beep 3 times indicating the
panel default values have been loaded.
7. Remove wiring between terminal 15 (PGM)
and terminal 3.
8. Re-install original wiring for terminal 15 (PGM)
and terminal 3.
Keypad Programming
Refer to WI80A for information on keypad pro-
gramming.
Downloading
The GEM-P400 panel can be download/up-
loaded with PCD3000 software using the Ring
Method, Answering Machine Override (Second
Call) or
Method of downloading. The
panel can also be automatically downloaded/up-
loaded using PCD2000 Software running
PCPreset. For Site Initiated Downloaded, see
Auto Download ID Number
[93].
Local Downloading
Wire as shown in Figure 1. Use the power up or
method of establishing a connection. The
power up method is recommended if the panel is
attempting to report.
Remote Downloading
Wire as shown in Figure 2. The panel can
be remotely download/uploaded using any
one of the following methods:
1. The
method
2. Call-in method
3. Answering Machine Override (Second
Call)
4. Site-Initiated (PCPreset &
)
5. Automatic Downloading (Using PCPreset)
PGM
(-)
+12
-13 14 15
16 17 18 19
+PWR GND GREEN TIP RING
PHONE
PCL2000A
GREEN
RED
MODEM
FIGURE
1
L
OCAL
D
OWNLOAD
TIP RING
TELCO
N
OTE
:
Any programming in
Dealer Options 1
[96] and
Dealer
Options 2
[97] will not be defaulted. If
Dealer Code
Lockout
has been programmed the panel will not default
the Dealer Code.
MODEM
J1
TO COMPUTER
J3
LOCAL
TO
PCI2000
J2
TO EXTERNAL
MODEM
J4
TELCO
J5 LINE
OUT TO
TELCO
FIGURE
2
R
EMOTE
D
OWNLOAD
PGM
(-)
+12
-13 14 15
16 17 18 19
+PWR GND GREEN
PHONETELCO
GREEN
RED
GEM-P400 Panel at the site
RING TIP RING
RJ31X
TIP
GRY
BRN
BLACKRED
Wi879a
page 5
Tuesday, September 16, 1997 08:16
To Next Page
Loading...
Need help?
General
