To Next PageTo Next Page
Need help?Do you have a question about the NAPCO GEMINI C Series and is the answer not in the manual?
General| Brand | NAPCO |
|---|---|
| Model | GEMINI C Series |
| Category | Control Panel |
| Language | English |
Explains the function of Direct Address Programming for panel customization.
Step-by-step guide for programming using binary data entry.
Step-by-step guide for programming using decimal data entry.
Step-by-step guide for programming using hexadecimal data entry.
Outlines the general procedure for programming the control panel.
Details reporting options for various system events and troubles.
Details reporting options for system events and troubles in areas 2-4.
Details reporting options for system events and troubles in areas 5-8.
Defines programming options for zones 1 through 8.
Defines programming options for zones 9 through 16.
Defines programming options for zones 17 through 24.
Defines programming options for zones 25 through 32.
Defines programming options for zones 33 through 40.
Defines programming options for zones 41 through 48.
Defines programming options for zones 49 through 56.
Defines programming options for zones 57 through 64.
Defines programming options for zones 65 through 72.
Defines programming options for zones 73 through 80.
Defines programming options for zones 81 through 88.
Defines programming options for zones 89 through 96.
Describes automatic zone option settings after exiting Easy Menu Driven Mode.
Configuration for various system behaviors and features.
Settings for Notification Appliance Circuits and relay types.
Configuration for various system behaviors and features.
How to assign codes for reporting various events.
Configuration for dialing prefixes and other system options.
Assigning a specific zone for fire drill activation.
Details how to configure SLC and RF receivers.
Specifies the number of external relay board modules.
Sets the type for Notification Appliance Circuits and outputs.
Sets reporting for fire events via Telco.
Configures the panel for unattended downloads.
Configures reporting for burglary events by area type.
Assigns types and areas to individual keypads.
Configures specific functions for burglary keypads.
Configures zone options for ACM doors.
Configures global ACM system flags.
Sets time limits for ACM access features.
Assigns areas to ACM doors for arming/disarming.
Sets up scheduled free access for ACM doors.
Configures emergency free access for ACM zones.
Configures ACM access and burglary module features.
Maps users to specific system areas for access control.
Maps users to specific system areas for access control.
Organizes zones into groups for EZM module programming.
Configures PGM output activation based on armed areas.
Sets arming priority between areas to ensure proper sequence.
Controls outputs based on area disarming events.
Sets up RF receivers and supervision timers for wireless devices.
Options to clear dealer program or perform a cold start reset.
