NAPCO GEMINI C Series - SYSTEM OPTIONS: TELEPHONE AND ZONE SETTINGS; TELEPHONE DIALING AND OTHER SETTINGS; ZONE TYPES; FIRE DRILL ZONE CONFIGURATION

NAPCO Security Group
NAPCO Gemini C-Series Control Panel Programming Instructions--Volume 2
Page 94 Programming Instructions, Volume 2
[Default = blank (•) blank (•)]
ADDRESS 8170
LEFT DIGIT (SUM
OF DATA VALUES)
RIGHT DIGIT (SUM
OF DATA VALUES)
blank (•)
LEFT DATA
VALUES
(CIRCLE )
1
2
4
8
SYSTEM OPTIONS
RESERVED
RESERVED
RESERVED
Skip Automatic
Dial Tone Detect
SYSTEM OPTIONS (ADDRESS 7928 -7947 & 8170)
Telephone Dialing
Prefix (Digits 1-20)
ADDRESS 7928-3901 (RIGHT DIGITS 1-20)
7928 7929 7930 7931 7932 7933 7934 7935 7936 7937 7938 7939 7940 7941 7942 7943 7944 7945 7946 7947
[Default = blank (•) blank (•) blank (•)]
Fire Drill Zone: Enter a dedicated zone number to be used only when a fire drill is activated.
Note: Prior central station notification of the drill is not necessary; the signal sent always indicates a fire drill
event only.
1. Valid entries are: 01 through 255.
Fire Drill Zone
ADDRESS 7963
ZONE TYPES (ADDRESS 7963)
SLC/RF RECEIVERS-- NUMBER, TYPE AND LOCATION (ADDRESS 7958- 7962)
Receiver Type and Location: Specify the "Receiver Type" by
selecting the address of the receiver number (Receiver 1 = ad-
dress 7959, etc.), and entering the Type number (right nibble data
entry) specified in the RECEIVER TYPE table, at right.
Note: All SLC / RF receivers must be added contiguously start-
ing with address 7959, then added through 7962 without skipping
addresses.
 Valid entries in the right nibble are: 01 through 03 as speci-
fied in the RECEIVER TYPE table. Note: Left nibble is al-
ways blank (•)
RECEIVER TYPE AND LOCATION
ADDRESS 7959-7962
RECEIVER
NUMBER
Address LEFT RIGHT COMMENTS
RECEIVER 1 7959
•
SLC MUST BE ON PCB SLC
PORT 1 ONLY
RECEIVER 2 7960
•
SLC MUST BE ON PCB SLC
PORT 2 ONLY
RECEIVER 3 7961
•
CANNOT BE SLC TYPE
RECEIVER 4 7962
•
CANNOT BE SLC TYPE
[Default = blank (•) from address 7959-7962]
RECEIVER TYPE
RIGHT DATA
ENTRY
DESCRIPTION
0 RF BURG BUS (GEMC-RECV on Burg bus)
1 RF FIRE BUS (GEMC-RECV on Fire bus)
2 SLC BURG 1/2 (GEMC-BSLC Burg SLC)
3 SLC FIRE 1/2 (GEMC-FW-SLC Fire SLC)
[Default = blank (•) blank (•)]
No. of SLC Modules /
RF Receivers
ADDRESS 7958
No. of SLC / RF Receivers: Enter the number of
Burg SLC modules, Fire SLC modules and/or
GEMC-RECV wireless receivers in this location.
1. Valid entries are: 01 through 04.
Note: Right digit is
RESERVED (not used).
Enter data in left digit only.