To Next PageTo Next Page
Need help?Do you have a question about the NAPCO Continental Access Accelaterm and is the answer not in the manual?
General| Brand | NAPCO |
|---|---|
| Model | Continental Access Accelaterm |
| Category | Control Panel |
| Language | English |
Wiring methods for single-conductor terminal blocks.
Wiring methods for barrier type terminal blocks.
Techniques for connecting multiple wires to a terminal.
Guidance on unpacking and inspecting electronic equipment.
Describes limited external cleaning and inspection.
Details the panel's programmable, self-contained access control capabilities.
Information on UL evaluation and system decision-making.
Guidance on installation security and fault tolerance.
Details access control capacity and reader interfaces.
Explains Ethernet and RS-485 communication modules.
Information on SRAM memory modules for expanded capacity.
Site selection and preparation for cabinet mounting.
Step-by-step guide for physically mounting the cabinet.
Classifies wiring types: power, low-voltage, and communication.
Proper grounding for electromagnetic compatibility and performance.
Safety procedures for grounding the AC power source.
Connecting the incoming AC voltage to the terminal block.
Steps for installing backup batteries for power continuity.
Diagram showing terminal locations on the main circuit board.
Connecting Wiegand and proximity readers to terminal strips.
Guidelines for connecting Wiegand-output keypads.
Connecting magnetic stripe readers to terminal strips.
Connecting door status sensors to terminal strips.
Connecting REX sensors to terminal strips for access control.
Explains relay configurations and fail-safe/fail-secure options.
Illustrates power connection examples for various lock types.
Routing power for locks via expansion boards.
Factors for using 24VDC equipment with the system.
Details the accessory power terminal strip functions.
Connecting and configuring supervised and unsupervised alarms.
Explains the built-in tamper switch operation.
Installing Ethernet and RS-485 repeater boards.
Setting network addresses and cable requirements.
Explains the functions of communication LEDs.
Details the function of '485 data pair connections.
Explains LED indicators on the Accelaterm circuit board.
Details PTC devices for protecting output circuits.
Protection against lightning-induced voltage surges.
Explains dielectric isolation for signal integrity.
Activation, replacement, and care of coin cells.
Procedures for replacing backup batteries.
Lists technical specifications for the Accelaterm system.
Details current draw for various components and battery backup.
Guide for installing the Ethernet plug-in module.
Instructions for installing the 8-reader expansion board.
Wiring instructions for the RS-485 repeater board.
Procedures for ordering, payment, and credit.
Policies on cancelled orders and merchandise returns.
Information on product warranty coverage and exclusions.
Important notices regarding product use and legal disclaimers.
Defines product liability and legal governing terms.
