NAPCO GEMINI C Series - EZM PGM TERMINAL CONTROL; PROGRAMMING PGM OUTPUTS

NAPCO Gemini C-Series Control Panel Programming Instructions--Volume 2
NAPCO Security Group
Programming Instructions, Volume 2 Page 105
ADDRESS 5640
EZM Group 61
ZONES 249-252
ADDRESS 5641
EZM Group 62
ZONES 253-255
EZM PGM ARMED TERMINAL CONTROL: For each zone group select the area(s) which, when armed, will
activate the PGM Lug on the corresponding EZM modules. Each zone group corresponds to 4 zones. If 8-Zone
EZMs are used each one is treated as TWO zone groups. NOTE: Lug goes ACTIVE (low) when ANY selected area
is armed. When activated, the PGM Lug goes negative (to Ground).
 1. Select the desired group number.
 2. Enter the corresponding Area number in each the address location, in Binary (Bit) Format. NOTE: See Direct
Address Programming Example on page 72.
 3. Press U to save.
GROUP
NUMBER
EZM PGM TERMINAL CONTROL
ADDR A1 A2 A3 A4 A5 A6 A7 A8
1 2 3 4 5 6 7 8
1 5648
2 5649
3 5650
4 5651
5 5652
6 5653
7 5654
8 5655
9 5656
10 5657
11 5658
[Default = blank (•) blank (•) from address 5648-5658]
GROUP
NUMBER
EZM PGM TERMINAL CONTROL
ADDR A1 A2 A3 A4 A5 A6 A7 A8
1 2 3 4 5 6 7 8
12 5659
13 5660
14 5661
15 5662
16 5663
17 5664
18 5665
19 5666
20 5667
21 5668
22 5669
[Default = blank (•) blank (•) from address 5659-5669]
EZM PGM TERMINAL CONTRO L (ADDRESS 5648-5669)
NOTE: Zones 1-8 are included in the control panel and Zones 9-255 (Groups 1-62) are available as EZM Zones (either Wireless or Hardwired).
EZM TYPE
DATA ENTRIES
(RIGHT)
OPTION
blank (•)
Not used (No
EZM present)
1 4-Zone EZM
EZM GROUP OPTIONS: Up to 62 Groups of 4 Zones each may be programmed
depending on the number of zones used and which EZM modules are connected. Each
group represents 4 zones.
1. Select EZM type from the table shown.
2. Enter either blank (•) or "1" in corresponding address locations above.
3. Press U to save