Napoleon BGD33NR - User Manual

1
W415-0662 / C / 04.11.12
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
NEVER LEAVE CHILDREN OR OTHER AT RISK INDIVIDUALS ALONE WITH THE APPLIANCE
INSTALLATION AND
OPERATING INSTRUCTIONS
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 0G8 Canada /
103 Miller Drive, Crittenden, Kentucky, USA, 41030
Phone (705)721-1212 • Fax (705)722-6031 • www.napoleonfi replaces.com • ask@napoleonproducts.com
1.28C
$10.00
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI/CSA METHODS.
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.
!
WARNING
SAFETY INFORMATION
!
WARNING
- Do not store or use gasoline or other fl ammable
vapors and liquids in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbour’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the
fi re department.
- Installation and service must be performed by a
qualifi ed installer, service agency or the supplier.
This appliance may be installed in an aftermarket,
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by
local codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is
not convertible for use with other gases, unless a
certifi ed kit is used.
If the information in these instructions
are not followed exactly, a fi re or
explosion may result causing property
damage, personal injury or loss of life.
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI/CSA METHODS.
GD33NR
BGD33NR
NATURAL GAS MODEL
GD33PR
BGD33PR
PROPANE GAS MODEL
GD33 IS CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS: CSA 2.33 ● ANSI Z21.88 FOR VENTED GAS FIREPLACE HEATERS
BGD33 IS CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS: CSA 2.22 ● ANSI Z21.50 FOR VENTED GAS FIREPLACES

Summary

SAFETY INFORMATION

INSTALLATION OVERVIEW

INTRODUCTION

DIMENSIONS

Provides physical dimensions for GD33 and BGD33 models.

GENERAL INSTRUCTIONS

General safety and operational guidelines for appliance installation.

GENERAL INFORMATION

Test-fire information, approval status, and operating notes.

RATING PLATE INFORMATION

Details on appliance specifications found on the rating plate.

VENTING

VENTING LENGTHS AND COMPONENTS

Specifies minimum/maximum vent lengths and approved components.

TYPICAL VENT INSTALLATION

Illustrates standard vertical and horizontal vent installations.

SPECIAL VENT INSTALLATIONS

Details periscope and corner termination vent installations.

VENT TERMINAL CLEARANCES

Details required clearances for vent terminals in various locations.

VENTING APPLICATION FLOW CHART

Provides a flowchart for determining vent configurations.

DEFINITIONS

Defines symbols used in venting calculations.

ELBOW VENT LENGTH VALUES

Lists equivalent lengths for vent elbows.

HORIZONTAL TERMINATION

Explains horizontal vent installation requirements and calculations.

VERTICAL TERMINATION

Explains vertical vent installation requirements and calculations.

INSTALLATION

WALL AND CEILING PROTECTION

Instructions for protecting walls and ceilings from heat and fire.

HORIZONTAL INSTALLATION

Step-by-step guide for horizontal vent pipe installation.

VERTICAL INSTALLATION

Steps for installing the venting system through a roof.

USING FLEXIBLE VENT COMPONENTS

Guidelines for using flexible venting components and spacers.

USING RIGID VENT COMPONENTS

Guidelines for using rigid venting components and support.

GAS INSTALLATION

Covers gas connection procedures and safety precautions.

OPTIONAL WALL SWITCH

Instructions for installing an optional remote wall switch.

HARD WIRE INSTALLATION

Details on hardwiring electrical components for the appliance.

VERTICAL THROUGH EXISTING CHIMNEY

Instructions for venting through a masonry chimney.

MOBILE HOME INSTALLATION

Specific installation requirements for mobile homes.

FRAMING

GD33 FRAMING

Specific framing instructions for the GD33 model.

MINIMUM FRAMING DIMENSIONS

Provides minimum framing dimensions for GD33 and BGD33 models.

BGD33 FRAMING

Specific framing instructions for the BGD33 model.

MINIMUM CLEARANCE TO COMBUSTIBLE ENCLOSURES

Specifies minimum clearances around the appliance.

ALCOVE INSTALLATION

Guidelines for installing the appliance in an alcove.

MINIMUM MANTEL CLEARANCES

Details required clearances for mantels.

FINISHING

DOOR REMOVAL AND INSTALLATION

Instructions for removing and installing the appliance door.

LOG PLACEMENT

Guide for correctly positioning logs for appearance and function.

BGD33

Log placement details specific to the BGD33 model.

GD33

Log placement details specific to the GD33 model.

CHARCOAL EMBERS (BGD33 ONLY)

Instructions for placing charcoal embers.

LOUVRE INSTALLATION

Steps for installing louvres.

LOGO PLACEMENT

Instructions for applying the logo to the glass door.

OPTIONAL BLOWER INSTALLATION

OPERATION

ADJUSTMENT

PILOT BURNER ADJUSTMENT

Steps to adjust the pilot flame size.

VENTURI ADJUSTMENT

Information on air shutter settings for flame appearance.

FLAME CHARACTERISTICS

Guidance on checking and identifying normal flame patterns.

RESTRUCTING VERTICAL VENTS

How to reduce vent gas velocity for flame appearance.

MAINTENANCE

CARE OF GLASS

Instructions for cleaning the appliance glass.

CARE OF PLATED PARTS

Guidance on cleaning and maintaining plated components.

DOOR GLASS REPLACEMENT

Step-by-step instructions for replacing door glass.

REPLACEMENTS

TROUBLESHOOTING

WARRANTY

Napoleon BGD33NR Specifications

General

Brand	Napoleon
Model	BGD33NR
Category	Indoor Fireplace
Language	English