EasyManua.ls Logo

Napoleon BGD36CFNTRE - User Manual

Napoleon BGD36CFNTRE
128 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
EN
FR
PG
65
W415-1345 / B / 10.22.15
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
NEVER LEAVE CHILDREN OR OTHER AT RISK INDIVIDUALS ALONE WITH THE APPLIANCE
INSTALLATION AND
OPERATING INSTRUCTIONS
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 0G8 Canada /
103 Miller Drive, Crittenden, Kentucky, USA, 41030
Phone (705)721-1212 • Fax (705)722-6031 • www.napoleonfi replaces.com • hearth@napoleonproducts.com
1.28F
$10.00
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.
!
DANGER
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this appliance
and shall be installed for the protection of children
and other at-risk individuals.
SAFETY INFORMATION
!
WARNING
- Do not store or use gasoline or other fl ammable
vapors and liquids in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbour’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the
fi re department.
- Installation and service must be performed by a
qualifi ed installer, service agency or the supplier.
This appliance may be installed in an aftermarket,
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by
local codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is
not convertible for use with other gases, unless a
certifi ed kit is used.
If the information in these instructions
are not followed exactly, a fi re or
explosion may result causing property
damage, personal injury or loss of life.
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI/CSA METHODS.
Decorative Product: Not for use as a heating appliance.
BARRIER
BGD36CFNTR &
BGD36CFNTRE
NATURAL GAS MODEL
BGD36CFPTR &
BGD36CFPTRE
PROPANE GAS MODEL
CONFORMS TO AMERICAN NATIONAL STANDARDS: ANSI Z21.50, CERTIFIED TO CANADIAN CSA 2.22 FOR VENTED GAS FIREPLACES.
SAFETY BARRIER

Table of Contents

Other manuals for Napoleon BGD36CFNTRE

Preview: Installation And Operation Manual
Installation And Operation Manual120 pages

Questions and Answers

  • J
    Jennifer HollandSep 10, 2025
    How to fix a blue, lazy flame on my Napoleon BGD36CFNTRE Indoor Fireplace?
    • A
      Anna VasquezSep 12, 2025
      If the main burner flame in your Napoleon Indoor Fireplace is blue, lazy, and transparent, ensure that the main burner is set to ‘HI’. Check the outlet pressure using screw (B). The gauge should read as described on the chart below. After taking pressure readings, be sure to turn screws clockwise firmly to reseal, but do not overtighten. Leak test with a soap and water solution.
  • C
    Claudia TaylorAug 25, 2025
    Why are the flames so aggressive in my Napoleon BGD36CFNTRE?
    • M
      Michelle DunlapAug 25, 2025
      If the flames in your Napoleon Indoor Fireplace are too aggressive, make sure the door is tightly sealed. The mechanical components securing the door should ensure a tight seal. Also, check that the venting is properly sealed, as excessive venting action can cause aggressive flames.
  • A
    Aaron RamirezAug 25, 2025
    How to fix a Napoleon BGD36CFNTRE when the pilot will not light?
    • A
      Alexander MendezAug 26, 2025
      If the pilot light of your Napoleon Indoor Fireplace will not light, start by checking if there is a spark at the pilot burner. You can test this by trying to light the pilot with a match. Also, ensure that the wire is securely connected to the push button igniter and that the igniter is properly tightened. If the wire insulation is broken or frayed, replace the wire. If the ceramic insulator on the electrode is cracked or broken, replace the electrode. If none of these steps work, consider replacing the push button ignitor.
  • J
    Joseph FuentesSep 23, 2025
    How do I troubleshoot poor flame rectification or a contaminated sensor rod on my Napoleon Indoor Fireplace?
    • J
      john85Sep 23, 2025
      To troubleshoot poor flame rectification or a contaminated sensor rod on your Napoleon Indoor Fireplace, verify the flame is engulfing the sensor rod to increase flame rectification. Verify correct pilot orifice is installed and inlet gas specifications to manual. Verify that the wire harness is firmly connected to module. Verify that the ceramic insulator around the sensor rod is not cracked, damaged, or loose. Finally, verify the connection from the sensor rod to the sensor wire.
  • X
    xfordSep 12, 2025
    How to fix a blocked vent in my Napoleon Indoor Fireplace?
    • S
      Steven GarciaSep 12, 2025
      If there's a blockage in the vent of your Napoleon Indoor Fireplace, remove the blockage. To minimize this from happening again, it is recommended that the vent lengths that pass through unheated spaces be wrapped with an insulated mylar sleeve.
  • J
    Jeffrey JordanSep 16, 2025
    How do I adjust the pilot flame to engulf the thermocouple on my Napoleon Indoor Fireplace?
    • M
      meganrodriguezSep 16, 2025
      To adjust the pilot flame to better engulf the thermocouple on your Napoleon Indoor Fireplace, gently twist the pilot head to improve the flame pattern around the thermocouple.
  • L
    Linda ScottSep 4, 2025
    What to do if my Napoleon BGD36CFNTRE Indoor Fireplace pilot sparks but won't light?
    • W
      whiterobertSep 4, 2025
      If the pilot sparks but will not light on your Napoleon Indoor Fireplace, verify that the incoming gas line ball valve is open and that the inlet pressure reading is within acceptable limits, not exceeding 14" W.C. Also, verify the valve and pilot assemblies are properly grounded to the metal chassis of the fireplace or log set. Finally, check to see if you are out of propane gas, and fill the tank if necessary.
  • P
    patelshannonSep 4, 2025
    Why won't the pilot light and there's no spark on my Napoleon BGD36CFNTRE Indoor Fireplace?
    • K
      Karen SmithSep 4, 2025
      If the pilot will not light and there is no spark at the pilot burner of your Napoleon Indoor Fireplace, check if the pilot can be lit by a match. Ensure that the wire is connected to the push button igniter and that the push button igniter is tightened. Also, verify if you are out of propane gas and fill the tank if necessary.
  • K
    Kristin WeberAug 29, 2025
    How do I troubleshoot defective wall switch wiring in my Napoleon BGD36CFNTRE?
    • S
      Scott ChenAug 29, 2025
      If you suspect the wall switch wiring in your Napoleon Indoor Fireplace is defective, disconnect the switch wires and connect a jumper wire across terminals 1 & 3. If the main burner lights, check the wires for defects and/or replace them.
  • J
    Jason DavisAug 30, 2025
    What to do if the valve is faulty in my Napoleon BGD36CFNTRE Indoor Fireplace?
    • J
      James BartonAug 30, 2025
      If the valve in your Napoleon Indoor Fireplace is faulty, replace it.

Napoleon BGD36CFNTRE Specifications

General IconGeneral
TypeDirect Vent Gas Fireplace
Vent TypeDirect Vent
Ignition TypeElectronic Ignition
FinishBlack
Log MaterialCeramic Fiber
Burner MaterialStainless Steel
Fuel TypeNatural Gas
EfficiencyUp to 70%
WarrantyLimited Lifetime Warranty

Related product manuals