Napoleon HDX40NT - Table of Contents

2
W415-0869 / A / 06.10.10
TABLE OF CONTENTS
NOTE: Changes, other than editorial, are denoted by a vertical line in the margin.
1.0 INSTALLATION OVERVIEW 3
2.0 INTRODUCTION 4
2.1 DIMENSIONS 5
2.2 GENERAL INSTRUCTIONS 5
2.3 GENERAL INFORMATION 6
2.4 RATING PLATE INFORMATION 7
3.0 VENTING 8
3.1 VENTING LENGTHS AND COMPONENTS 8
3.2 TYPICAL VENT INSTALLATIONS 10
3.3 SPECIAL VENT INSTALLATIONS 11
3.3.1 PERISCOPE TERMINATION 11
3.3.2 CORNER TERMINATION 11
3.4 VENT TERMINAL CLEARANCES 12
3.5 VENT APPLICATION FLOW CHART 13
3.6 DEFINITIONS 13
3.7 ELBOW VENT LENGTH VALUES 13
3.8 HORIZONTAL TERMINATION 14
3.9 VERTICAL TERMINATION 16
4.0 INSTALLATION 18
4.1 WALL AND CEILING PROTECTION 18
4.1.1 HORIZONTAL INSTALLATION 19
4.1.2 VERTICAL INSTALLATION 19
4.2 USING FLEXIBLE VENT COMPONENTS 20
4.2.1 HORIZONTAL AIR TERMINAL INSTALLATION 20
4.2.2 VERTICAL AIR TERMINAL INSTALLATION 21
4.3 MOBILE HOME 22
4.4 ACCESS PANEL FOR GAS LINE CONNECTION 22
4.5 GAS INSTALLATION 23
5.0 FRAMING 24
5.1 MINIMUM CLEARANCE TO COMBUSTIBLES 26
5.2 MINIMUM CLEARANCE TO COMBUSTIBLE ENCLOSURES 27
5.3 MINIMUM MANTEL CLEARANCES 29
6.0 FINISHING 30
6.1 DOOR REMOVAL / INSTALLATION 30
6.2 LOG PLACEMENT 31
6.3 GLOWING EMBER PLACEMENT 32
6.4 LAVA ROCK 32
6.5 OPTIONAL ROCK PLACEMENT 33
6.6 LOGO PLACEMENT 34
7.0 OPTIONAL BLOWER INSTALLATION 35
7.1 ACCESSING THE BLOWER 35
7.2 INSTALLING THE BLOWER 36
8.0 WIRING DIAGRAM / ELECTRICAL INFORMATION 37
8.1 WIRING REQUIREMENTS 37
8.2 OPTIONAL ACCESSORIES REQUIREMENTS 37
8.3 JUNCTION BOX INSTALLATION 38
8.4 WIRING DIAGRAM 39
9.0 OPERATION 40
10.0 ADJUSTMENT 41
10.1 PRESSURE ADJUSTMENT 41
10.2 VENTURI ADJUSTMENT 41
10.3 FLAME ADJUSTMENT 41
10.4 FLAME CHARACTERISTICS 42
11.0 MAINTENANCE 42
11.1 LAMP REPLACEMENT 43
11.2 DOOR GLASS REPLACEMENT 44
11.3 CARE OF GLASS 44
11.4 CARE OF PLATED PARTS 44
12.0 REPLACEMENT PARTS 45
13.0 TROUBLESHOOTING 48
14.0 WARRANTY 50
15.0 SERVICE HISTORY 51