6
1. Open grill lid.
2. Push and turn any main burner knob slowly to the ’hi’ posion. This acon will ignite the
pilot ame which will in turn light the selected burner. If the pilot lights, connue to push
down on the control knob unl the burner lights and then release.
3. If the pilot does not ignite, then immediately turn the control knob back to the ‘o posion
and repeat step 2 several mes.
4. If the pilot and burner will not ignite within 5 seconds, turn the control knob to the ‘o’
posion and wait 5 minutes for any excess gas to dissipate. Either repeat steps 2 and 3 or light
with a match.
5. If lighng the unit with a match, clip the match into the supplied lighng rod. Hold the lit
match down through the grill and sear plate while turning the corresponding burner valve to
high.
To Next Page
Loading...
