LATHE
OPEBATION
CAUTIONS
-
-
To
safeguard
against damage or injury, it
is recommended that the operator read carefully
all
instructions
in this manual
before
beginning operation of the
lathe.
*
Check the
oil
level
of the headstock
and
lubrication
of
the
threads, feeds
gear
box
and
all
other
lubrication
points.
Tlre
!athe leaves
the factory correctly
lubricated at all
points,
hut a
general
inspectiorr
befr:re
operatir:n
is inrportant.
-* Before cleaning the lathe,
verify
that the spindle lever is in the center
position.
--
Until
the
operatoi
has hrecome completely
familiarized
with all the
lathe's
controls,
he
should
operate
it
only
with
the motor
at
low
speed.
IMPORTANT-
Do not change speeds,
threads or
feeds
selectors
with the spindle in motion. This can
wear
or
break
the
gear
teeth.
13
To Next Page
Loading...