CALIBRATION PROCEDURE
NI PXIe-4464
4-Channel, 204.8 kS/s DSA Input
This document contains the verification and adjustment procedures for the National Instruments
PXIe-4464. The NI PXIe-4464 is available in two input connector variants: BNC and mXLR.
The calibration procedure is common between them; only the connecting cabling is different. In
this document, the BNC and mXLR variants are referred to inclusively as the NI PXIe-4464. For
more information about calibration solutions, visit
ni.com/calibration.
Contents
Software.................................................................................................................................... 1
Documentation.......................................................................................................................... 2
Test Equipment......................................................................................................................... 2
Test Conditions......................................................................................................................... 5
Initial Setup............................................................................................................................... 5
Verification ............................................................................................................................... 6
Adjustment................................................................................................................................ 16
Reverification ........................................................................................................................... 18
Updating the Calibration Date without Performing Adjustment.............................................. 18
Specifications............................................................................................................................ 19
Where to Go for Support .......................................................................................................... 19
Software
Calibrating the NI PXIe-4464 requires the installation of NI-DAQmx on the calibration system.
NI-DAQmx 14.1 added driver support for the NI PXIe-4464. For the list of devices supported
by a specific release, refer to the NI-DAQmx Readme, available on the version-specific
download page or installation media.
You can download NI-DAQmx from
ni.com/downloads. NI-DAQmx supports LabVIEW,
LabWindows
™
/CVI
™
, C/C++, C#, and Visual Basic .NET. When you install NI-DAQmx, you
only need to install support for the application software that you intend to use.
To Next Page
Need help?
General