Figure 1. sbRIO-9627 Kit Contents
1. sbRIO Device
2. NI CompactRIO Device Drivers Media
3. Getting Started Guide
4. Power Supply
5. 10-pin IDC to 9-pin DSUB Cable
6. 50-pin IDC Ribbon Cable
7. Power Cable Assembly
8. Standoffs and Screws
9. NI 9694 Digital I/O Breakout RMC Board
Note The provided power supply is only intended for the getting started
experience. NI recommends the use of a power supply that meets the specifications
listed in the NI sbRIO-9627 Specifications for system deployment.
Installing Software on the Host Computer
Before using the sbRIO-9627, you must install the following application software and device
drivers on the host computer.
1. LabVIEW 2015 or later
2. LabVIEW Real-Time Module 2015 or later
3. LabVIEW FPGA Module 2015 or later
4. NI CompactRIO Device Drivers August 2015 or later
For minimum software support information, visit ni.com/info and enter the Info Code
softwareversion.
Connecting the sbRIO-9627
The sbRIO-9627 has the following components.
4 | ni.com | NI sbRIO-9627 Getting Started Guide
To Next Page
Loading...
