OEM OPERATING INSTRUCTIONS AND SPECIFICATIONS
NI sbRIO-9605/9606 and
NI sbRIO-9623/9626/9633/9636
Single-Board RIO OEM Devices
This document provides dimensions, pinouts, connectivity information,
and specifications for the National Instruments sbRIO-9605, sbRIO-9606,
sbRIO-9623, sbRIO-9626, sbRIO-9633 and sbRIO-9636. The devices are
referred to inclusively in this document as the NI sbRIO device.
The NI sbRIO device is available in different configurations. When a
feature pertains only to specific models, a list at the beginning of the section
shows which models support the feature.
Figure 1. NI sbRIO-9636
Caution The NI sbRIO device must be installed inside a suitable enclosure prior to use.
Hazardous voltages may be present.
Caution National Instruments makes no product safety, electromagnetic compatibility
(EMC), or CE marking compliance claims for NI sbRIO devices. The end-product supplier
is responsible for conformity to any and all compliance requirements.
Caution Exercise caution when placing NI sbRIO devices inside an enclosure. Auxiliary
cooling may be necessary to keep the local ambient temperature under the maximum rating
for the NI sbRIO device. Refer to the Specifications section for more information about the
maximum local ambient temperature rating.
To Next Page
Need help?
General
