NI sbRIO-960x/962x/963x OEM Instructions & Specifications 2 ni.com
Caution Do not operate the NI sbRIO device in a manner not specified in these operating
instructions. Product misuse can result in a hazard. You can compromise the safety
protection built into the product if the product is damaged in any way. If the product is
damaged, return it to National Instruments for repair.
What You Need to Get Started
This section lists the software and hardware you need to start programming
the NI sbRIO device.
Software Requirements
You need a development computer with the following software installed
on it. Go to
ni.com/info and enter the Info Code rdsoftwareversion
for information about software version compatibility.
❑ LabVIEW 2011.1 or later
❑ LabVIEW Real-Time Module 2011.1 or later
❑ LabVIEW FPGA Module 2011.1 or later
❑ NI-RIO 4.1 or later
Hardware Requirements
You need the following hardware to use the NI sbRIO device.
❑ NI sbRIO device
❑ 9–30 VDC power supply
❑ Power plug assembly
❑ Ethernet cable
To Next Page
Loading...
