National Instruments sbRIO-9605

© National Instruments 53 NI sbRIO-960x/962x/963x OEM Instructions & Specifications
AO accuracy
Note For information about measuring the local ambient temperature, refer to the
Environmental section.
INL ......................................................... ±0.018% of range, max
Capacitive drive ..................................... 1 nF, typical
Slew rate................................................. 0.75 V / µsec, typical
NI sbRIO-9626/9636
Number of channels ............................... 4
DAC resolution ...................................... 16 bits
Max update rate
1
.................................... 336 kS/s
Range ..................................................... ±10 V
Overrange operating voltage
Minimum ........................................ 10.3 V
Typical ............................................ 10.6 V
Max ................................................. 10.9 V
Output impedance .................................. 0.4 Ω typical
Current drive .......................................... ±3 mA / channel max.
Protection ............................................... Short-circuit to ground
Power-on state
2
...................................... 0 V
Measurement Conditions
Percent of Reading
(Gain Error)
Percent of Range
*
(Offset Error)
Typical (25 °C, ±5 °C) 0.12% 0.02%
Max (–40 to 85 °C) 0.80% 0.12%
*
Range is 5 V.
1
This is the maximum update rate when running one AO channel in a loop with the FPGA top-level clock set to 40 MHz.
2
When the analog output initializes, a glitch occurs for about 20 µs, peaking at 1.3 V, typical.