SPECIFICATIONS
NI sbRIO-9627
Single-Board RIO OEM Devices
This document lists the specifications for the NI sbRIO-9627. The following specifications are
typical for the -40 °C to +85 °C operating temperature range unless otherwise noted.
Caution Do not operate the sbRIO-9627 in a manner not specified in this
document. Product misuse can result in a hazard. You can compromise the safety
protection built into the product if the product is damaged in any way. If the product
is damaged, return it to NI for repair.
Processor
Type Xilinx Zynq-7000,
XC7Z020 All Programmable SoC
Architecture ARM Cortex-A9
Speed 667 MHz
Cores 2
Operating system NI Linux Real-Time (32 bit)
Nonvolatile memory
1
512 MB
Volatile memory (DRAM) 512 MB
Real-time clock, accuracy 5 ppm
Flash reboot endurance
2
100,000 cycles
Note For information about the life span of the nonvolatile memory and about best
practices for using nonvolatile memory, visit ni.com/info and enter the Info Code
SSDBP.
1
Formatted nonvolatile memory may be slightly less than this value.
2
You can increase the flash reboot endurance value by performing field maintenance on the device.
If you expect that your application may exceed the maximum cycle count listed in this document,
contact NI support for information about how to increase the reboot endurance value.
To Next Page
Need help?
General
