Unpacking the Kit
Caution To prevent electrostatic discharge (ESD) from damaging the device,
ground yourself using a grounding strap or by holding a grounded object, such as
your computer chassis.
1. Touch the antistatic package to a metal part of the computer chassis.
2. Remove the device from the package and inspect the device for loose components or any
other sign of damage.
Caution Never touch the exposed pins of connectors.
Note Do not install a device if it appears damaged in any way.
3. Unpack any other items and documentation from the kit.
Store the device in the antistatic package when the device is not in use.
Verifying the Kit Contents
Figure 1. Kit Contents
LINK
PWR
TX OUTPUT MAX +20 dBm, RX INPUT MAX -15 dBm, ALL RF PORTS 50 W
TX1 RX1
RX2
GPS
PPS
REF
TX1 RX1
RX2
AUX I/O
3.3 VDC MAX
RF 0
RF 1
NI USRP-2943R
1.2 GHz - 6 GHz
NI USRP-2943R
1.2 GHz - 6 GHz
Designed by Ettus ResearchDesigned by Ettus Research
JTAG
1
54
3
2
1. USRP RIO Device
2. SMA Driver Bit (USRP-2945 Only)
3. Getting Started Guide (This Document)
4. SMA (m)-to-SMA (m) Cable
5. 30 dB SMA Attenuator (Not Included with
USRP-2945)
Caution If you directly connect or cable a signal generator to your device, or if
you connect multiple USRP RIO devices together, you must connect a 30 dB
attenuator to the RF input (RX1 or RX2) of each receiving USRP RIO device.
USRP-2940/2942/2943/2944/2945 Getting Started Guide | © National Instruments | 3
To Next Page
Loading...
Need help?
General
