KORE 2 – 150
3.8.12 Flanger
The Flanger is a classic modulation effect that produces a metallic,
swooshing sound. It is very versatile and can be used on a wide range
of different material. It works by splitting the input signal into two paths
and delaying one of them by a very short amount. This produces a comb
lter effect.
Label Function Range Unit
Inverse
Phase inversion of one of the split signal parts. This produces a different
sound, which acts on the signals of the complete effect, as opposed on [Feed-
back] with negative values (see below).
On/Off
Mix
Controls the balance between the dry, unprocessed signal (at the left) and the
wet, processed signal (at the right).
0..100 %
Center
The higher the value the shorter the internal delay times leading to a shift of
the resulting comb lter effect to higher frequencies. This interacts with the
modulation, as it is added to this value (have a look at the Modulation Meter).
0..100 %
Mod Sync Synchronizes the modulation oscillator to KORE 2’s time base. On/Off
Rate
If [Mod Sync] is off, this controls the frequency of the
modulation oscillator.
0.04..25 Hz
To Next Page
Loading...
