KORE 2 – 151
Keyboard shortcut Function Range Unit
Depth Controls the intensity of modulation applied to the delay time. 0..100 %
Modulation Meter
Shows the delay time resulting from the setting of [Center] and the added
modulation signal.
Phase L/R Changes the phase of the left and right signal paths, respectively. -180..+180 deg
Feedback
Sets the amount of Feedback, i.e. how much of the output signal is fed back
into the input. With a negative Feedback the output of the internal delay line
is inverted before it is fed back into the input. This leads to a different set of
peaks and drops in the spectrum.
-100..100 %
Low Cut
High Cut
Sets the cutoff frequencies of the low pass/high pass lters modifying the
feedback signal. Frequencies above/below the set cutoff are attenuated.
25..1000/
10..20000
Hz
To Next Page
Loading...
