KORE 2 – 174
Label Function Range Unit
Pattern Grid
Sets one delay tap per track. The delay tap will sound at that position on
the time grid.
Feedback Sets the feedback level for the taps individually or on a global level. -60..0 dB
Pan
Controls the individual positions of the taps in the stereo-eld from com-
pletely left (-100%) to completely right (+100%).
-100..+100 %
Level Sets the output level for each tap individually. -60..0 dB
Filter Low/High Cut
Sets the cutoff frequency of the low pass/high pass lters that modify the
delayed signal. Frequencies below/above are attenuated with a slope of 12
dB per octave.
10..5000/
100..25000
Hz
3.8.27 Phaser
The P
HaSer
adds a swirling and animated effect to the signal. It is somewhat
similar to the Flanger, but generally warmer sounding and without the
metallic aspects. It works by delaying the input signal by a minuscule
amount and mixing it with the original. This leads to slight differences in
the phase between input and effects signal.
To Next Page
Loading...
