KORE 2 – 175
Label Function Range Unit
Mix Dry-Wet
Sets the balance between the dry, unprocessed signal and the “wet” (ltered)
one.
0..100 %
Center
Changes the cutoff frequency of the internal allpass lters of the Phaser, lead-
ing to a shift in phasing frequencies. This interacts with the modulation, as it is
added to this value (have a look at the Modulation Meter).
0..100 %
Modulation Sync Synchronizes the frequency of the LFO to KORE 2’s time base. On/Off
Modulation Rate Adjusts the delay time modulation speed, i.e., the internal LFO’s frequency. 0..10 Hz
Modulation Depth Sets the amount of modulation as a percentage of the delay time 0..100 %
Modulation LR Phase
Sets the phase offset of the LFO modulating the right or left channel delay
times, respectively. At the maximum setting the
0..180
De-
grees
Color Feedback
Feeds the output of the chain of allpass lters back into its input leading to a
shift in phasing frequencies.
-100..+100 %
Color Bandwidth
This inuences the way the phase rotation changes with higher frequencies lead-
ing to a different set of peaks and dips in the spectrum. Higher settings spread
the frequencies at which the peaks and dips sit.
0..100 %
Color Low Cut
Sets the cutoff frequency of a lowpass lter in the chain of allpass lters. Use
this to block out unwanted low frequency resonances.
25..800 Hz
Invert Mix If on, the processed signal is phase-inverted before being mixed with the input. On/Off
To Next Page
Loading...
