KORE 2 – 181
Label Function Range Unit
Modulation LR Phase
Sets the phase offset of the LFO modulating the right or left channel delay
times, respectively. At the maximum setting the LFO signal is 180° out of
phase.
0..180 Degrees
Feedback Amount
Sets the amplitude of the delayed signal that is fed back to the effects input.
High settings result in anging sounds.
0..0,995
Inverse Feedback Turns phase inversion of the feedback signal on or off. On/Off
3.8.32 Stereo Mix
The Stereo Mix is a very useful utility as well as an effect. It enables you
not only to control the left/right balance of a stereo signal and to swap
the channels, but it also allows you to split the signal into two frequency
bands and map those bands into the stereo spectrum.
To Next Page
Loading...
