The Main Bus Effects contains the following controls:
1. EQ: A 4-band xed EQ that can be used to boost or cut frequencies from the main signal. The 4
available knobs set the gain for each band.
2. Ambience: Controls the level of a very small reverb effect, this can be used to add distance to
the sound but without making it sound like it is in as large a space as the Reverb effect.
3. Punch: Turning this knob to the right will emphasize the transient peaks in the sound, making
it more percussive and punchy.
4. Comp: Controls the amount of compression applied to the Main Bus. Higher values reduce the
distance between the loudest and quietest parts of the signal.
5. Tape: Controls the amount of analog tape saturation applied to the Main Bus, making the
signal warmer and slightly compressed.
MIXER V IEW 33
To Next Page
Loading...