natus ALGO 5 - Page 20

20 ALGO® 5 Newborn Hearing Screener Service Manual
P/N 000995 Rev.A
10.3. Full Size Printer – Laser (no external Power Supply required)
• Unpack the Laser Printer. Set the printer on the bottom shelf of the cart.
• Route the 3-prong plug (the only unused connection from the Isolation
Transformer) through the bottom opening in the cart column and plug it into
the printer.
11. CLOSE THE CART COLUMN
When all of the above installation steps are completed, the covers that protect the cable
system are snapped into place. After the cover is in place, install the Column Cap with
the four button head cap screws ((#1/4-20 x 3/8” BHSCS) using the 5/32” allen wrench.
FIGURE 27 shows the fully assembled ALGO 5 with protective covers in place.
FIGURE 27: ALGO 5 —rear view with column cover snapped in