NAVEE S60 - Page 8

07 08
EN EN
Wheels, brake pads and other vulnerable parts are worn or damaged and need to be replaced, please contact the
after-sales service in time.
Item
Service
Object
Actions
Every
month
Every
3 months
Every
500 km/
6 months
Every
1000 km/
1 year
Every
10000 km/
3 years
Functions
Brake
Adjustment
Before adjusting, make sure the
scooter is turned o and not being
charged.
Tool: 5/14 mm hex key (the tool
needs
to be prepared by the user).
When the brake is too tight, use
the tool to turn the nut on the
screw rod counterclockwise, so
as to slightly shorten the brake
cable's exposed bottom part.
When the brake is too loose, use
the tool to turn the nut on the
screw rod clockwise, so as to
slightly lengthen the brake cable's
exposed bottom part.
√ √ √
Charging
Charge the scooter at a suitable
temperature. The indicator on
the battery charger is red when
the scooter is charging, and
turns green when the scooter is
fully charged. The control panel
will show the charging status
simultaneously during charging.
√ √ √
Steering
Turn the handlebar 60° to the left
and right to make sure the turning
angle is correct and the steering
is free from resistance and
stagnation.
√ √
Important
Components
Battery
Assembly
Fully charge the scooter before
leaving it unused for a long time,
and turn it on to charge every 60
days.
√
Scooter Maintenance Schedule (Recommended):
Maintaining the scooter regularly can help keep the scooter neat and in good condition, avoid safety hazards,
minimize breakdowns, slow down the deterioration of the scooter, and extend the scooter's service life.
Item
Service
Object
Actions
Every
month
Every
3 months
Every
500 km/
6 months
Every
1000 km/
1 year
Every
10000 km/
3 years
Tires
Tire Pressure
Inflate the tire until its
pressure reaches
45-50 psi.
√ √ √ √
Tire Tread
Wear
Check whether the tire is
cracked, deformed, worn,
etc.
√ √ √
Screws
Handlebar
Assembly
Screws
Tighten the screw that
connects the handlebar
assembly with the stem
assembly (with the
recommended torque of
4.8 ± 0.2 N·m).
√ √ √ √
Tighten the accelerator
screw (with the
recommended torque of
1.6 ± 0.1 N·m).
√ √
Tighten the brake
lever screw (with the
recommended torque of
5 ± 0.2 N·m).