Navien NaviCirc User Manual

34
Wiring Connection Table
Terminal Wiring Connection
Signal1
12 V
Contacts for wireless push button or motion
sensor connection
Signal
GND
5 V
Signal2
(Not polarity
sensitive)
Push Button Switch Contact #1
Push Button Switch Contact #2
Sensor I Contacts for temperature sensor connection
Connecting Wired Switches
Refer to the following diagrams to connect a wired switch, or
multiple wired switches to the HotButton controller.
CE1
CE2
U1
C1 C2
C7
R6
PC1
12 V 5 V SIGNAL
SIGNAL 1
GND
R5
R9
R8
C3
R1
R2
R7
D1
CON3
CON5
CON2
CON1
SIGNAL 2 SENSOR I
RA1
1 2 3 4
ON
SW1
Note
●
Multiple wired switches may be connected to the
same terminal contacts.
●
Use spade connectors at the end of the cables to
securely install the cables to the terminal contacts.

Navien NaviCirc Specifications

General

Brand	Navien
Model	NaviCirc
Category	Control Unit
Language	English