12
FUEL 3100 / DIESEL 3200 Installation and Operation Manual
NAVMAN
FUEL
Set fuel in tank(s) when
you add or remove fuel
(see section 5)
Twin tanks: section 3-1
3-3 Setup Menus and data
From the main display, press ENT + ESC together
to start setup mode. Press or until desired
menu is desplayed then press ENT to select it.
Press ESC again to return to the main menu.
Speed menuFuel menu
dUAL
Set number of fuel tanks
Off: 1 tank
On: 2 tanks
See section 3-2
SIZE
Set capacity of fuel
tank(s)
See section 3-3
motor
Set number of engines,
1 or 2
See section 3-1
CAL .F
Calibrate fuel sensor(s)
(see section 3-4)
Twin engines:
See section 3-3
dAmP.F
Set fuel damping
see section 3-5)
InPUt
Select speed input:
No: None
GPS: GPS/NMEA
SEn: Paddlewheel
sensor (see section3-6)
dAmP.S
Set speed damping (see
section 3-7)
CAL .L
Calibrate speed sensor
from log (see section
3-8)
CAL .S
Calibrate speed sensor
from boat speed
(see section 3-9)
Press or to select a setup menu
Press or to select setup data
Only available if InPUt = SEn
See also section 4-1
Select port or starboard engine
Press ENT for 2 secs to reset
to single engine installation.
A BEEP will sound when
complete.
Power port sensor only.
See section 3-2.
Press and hold ENT for
2 seconds to configure port
screen to port sensor. A BEEP
will sound when complete.
Press or to view
screens below.
Power starboard sensor
only. See section 3-4.2.
Press ENT for 2 seconds to
configure starboard screen
to starboard sensor. A BEEP
will sound when complete.
ENT
ENT
ESC
ESC
ESC
To Next Page
Loading...
General