EasyManuals Logo

Navman FUEL 3100 User Manual

Navman FUEL 3100
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
FUEL 3100 / DIESEL 3200 Installation and Operation Manual
NAVMAN
b Speed sensor cable is unplugged or
damaged. Perform a visual check.
c Speed calibration is incorrect (see sections
3-8 and 3-9).
d Interference from electrical noise may be
affecting the measurements. Review the
installation.
5 Low Fuel Alarm sounds when fuel not
low:
a The fuel REMAINING reading is incorrect.
The fuel tank capacity (SIZE) may be
incorrect, or the fuel REMAINING setting
may not have been updated after a refill.
See sections 2-6. and 5.
6 The display unit fogs:
a Moist air has entered the breathing tube at
the rear of the unit. Air the boat or run the
instrument with backlight fully on.
b Water has entered the breathing tube.
Return the instrument for servicing.
7. Flow indicates no fuel or low fuel
a FUEL 3100: Check that the fuel cable
connectors are securely plugged in and
the collar is locked in place. The collar must
be locked in place to give a watertight
connection.
b A fuel sensor may be clogged. If so, remove
the sensor from the fuel line and gently
blow through it in the opposite direction to
the fuel flow. A fuel filter between the fuel
sensor and the fuel tank must be installed
as per the fuel installation guide. Failure to
do so will void the warranty.
c Inspect the fuel cable from end to end for
damage such as cuts, breaks, squashed or
trapped sections.
d Check that the fuel filter is clean.
8 Fuel used or remaining seem inaccurate:
a In rough seas, fuel may surge back and
forth through the fuel sensor, resulting in
incorrect readings. Try installing a one-way
valve between the fuel sensor and the fuel
tank.
b The amount of fuel must be reset after
every refuelling (see section 5 ).
c The fuel tank may not refill to the same
capacity each time due to air pockets. This
is particularly noticable with underfloor
tanks (see section 5).
d Petrol fuel sensors wear out over time and
should be replaced after every 5000 litres
of fuel.
9 A twin engine installation shows only
one flow rate:
a Check that the number of engines is set to 2
(motor in the FUEL menu, see section 3).
10 There is no reading for fuel economy:
a The boat must be travelling through the
water to generate an economy reading.
b If an optional paddlewheel sensor is fitted,
check that the paddlewheel spins freely.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Navman FUEL 3100 and is the answer not in the manual?

Navman FUEL 3100 Specifications

General IconGeneral
BrandNavman
ModelFUEL 3100
CategoryMonitor
LanguageEnglish