EasyManua.ls Logo

NCE NCE897DVD - S D C a R D O P E R a T I O N; A U X I N P U T O P E R a T I O N

NCE NCE897DVD
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
SD Card operation
Turn on the unit by pressing button 1 (Once installed it will
turn on and off automatically with your ignition). Open and remove the
control panel as per the instructions on page 1. exposing the SD Card
slot, push in the sd card untill it clicks into place into the SD Card slot
9. Press button 1 to select SD CARD mode (Depending on your devise
this may occur automatically) it will begin to playback automatically,
use forward and back buttons 11 and 12 to navigate through your tracks,
press buttons 6 and 7 to move forward and back in 10 track increments.
Long press buttons 6 and 7 to go forward and back through folders.
To remove your SD Card open and remove the control panel as per
instructions on page 1 to expose the SD Card slot push the SD Card in
slightly until you hear the click then release.
Should the unit fail to playback contents of your device it is possible
that the recorded format is not supported, there are many different
types of formats some even sharing the same main name, if this
occurs try changing the format of your recordings.
3.5mm AUX input operation
Turn on the unit by pressing button 1, (Once installed it will
turn on and off automatically with your ignition). Use a 3.5mm jack
to plug your device into the AUX input. Press button 1 to select AUX
mode then use your device to playback media. Note that the volume and
setting of your device will directly affect the sound, so it is
recommended that you use the sound features of the unit and your
device to get the best sound results.
Sound adjustments
Use the volume knob 10 to adjust the volume up and down, press down
on 10 to access the sound controls BASS-TREBLE-FADER-BALANCE,
once you have chosen the control you need to adjust twist knob 10
clockwise to increase and anticlockwise to decrease the value. In fader
it will shift the sound from front to rear speakers and in balance mode
it will shift sound left to right speakers. Note if you have the preset
equaliser turned on you will need to turn it off to manually adjust the
bass and treble controls.
OPERATIONS