8
Radio operation
Turn on the unit by pressing button 1 (Once installed the unit will
turn on and off automatically with your ignition). Press button 1 again
to select the radio mode and button 13 to select the band. You can
then use the forward and back buttons 11 and 12 to select your desired
stations. You can use buttons 2-7 to preset your radio stations, to
preset your desired station firstly choose the station you wish to
programe then hold down one of the buttons from 2-7 to program
into that particular location.
USB operation
Turn on the unit by pressing button 1 (Once installed it will
turn on and off automatically with your ignition). Open the USB panel
exposing the USB connection, plug in your USB device. Press button 1
to select USB mode it will begin to playback automatically (Dependent
on your device), use forward and back buttons 11 and 12 to navigate
through your tracks, press buttons 6 and 7 to move forward and back in
10 track incraments. Long press buttons 6 and 7 to move forward and
back through folders. To remove your device press button 2 to stop
playback then remove device. Should the unit fail to playback contents
of your device it is possible that the recorded format is not supported,
there are many different types of formats some even sharing the same
main name, if this occurs try changing the format of your recordings.
Clock operation
To setup the clock, in tuner mode press button 8 to display the time
press and hold the to adjust the clock, the time will flash. Use the
button (10), anticlockwise to adjust the hour and clockwise to adjust
the minute. Once completed wait a few seconds and the clock will store.
OPERATIONS
To Next Page
Loading...