"Loaded from . . .": How the access device loaded its latest firmware update.
The "Close" button closes the options menu.
The “Setup” Menu
Within the “Options” screen, the "Setup" button brings up a set of tabs for viewing and
changing the access device settings. Note that this is an optional step to be used for
more control of the device.
The "Save" button saves all the changes made in the tabs and closes the window. This
brings the user back to the host PC list.
The "Cancel" button discards all the changes made in the tabs and closes the window.
This brings the user back to the host PC list.
The “Network” Tab
The "Network" tab contains settings for network connectivity.
If you have an IP Address, click on the "Use Static IP Address" radio button to set an IP
address and gateway address for the access device to use.
Otherwise, click on the "Get Dynamic IP Address" radio button to configure the access
device to use DHCP to get its IP address.
The MAC address is shown here for reference.
To Next Page
Loading...
Need help?
General
