"Setup" button in the "Options" sub-menu, they will be asked to enter the password. No
other menus are affected by this password.
NComputing recommends setting the password to improve security.
The “Update” Tab
Your NComputing L-Series access device may at times require a firmware update. To do
this, select the "Update" tab and click on the "Update" button. When the access device
asks you for a password, enter "updateme" (without the quotes). Your access device will
walk you through the process of updating the firmware.
It is crucially important that you follow the instructions. If you turn off the access device
during the firmware update process, it may become non-functional.
After the firmware update process is complete, reset the access device by turning it off
and on.
Certain changes in the vSpace software require a firmware update in each access
device connecting to it. NComputing notifies customers when a firmware update is
required by a given vSpace software update.
Using the vSpace Management Console
Start the admin console from the Windows Start menu. The application is called,
"vSpace Console."
You can also start the management console by right-clicking on the NComputing icon in
the system tray and selecting "vSpace Management Console" or by simply double-
clicking on the NComputing icon in the system tray.
The current color of the NComputing system tray icon displayed on the administrator’s
host station provides vSpace services status information.
vSpace is enabled and
running normally.
vSpace is enabled and running,
but a minor system module
inconsistency has been noted.
Please check NComputing online
Knowledge Base for any
recommended software update.
vSpace has been
disabled on this
system.
To Next Page
Loading...
Need help?
General
