X350/X550 User Manual
Page 39
The "System Settings" item shows the following settings for the terminal services
software. Double-clicking on the name of the setting allows you to adjust it, unless it is
read-only, which is specified below.
• Maximum number of stations (incl. Host): the maximum number of sessions
the vSpace software is configured to support. This number includes the host PC.
This setting is read-only.
• Current number of additional stations: the number of additional stations. This
setting is read-only.
• This machine: the name of the host PC. This setting is read-only.
• This user: the currently logged-in user’s username. This setting is read-only.
• System uptime: how long the system has been up. This setting is read-only.
• Start stations at boot?: whether or not the stations start when the host PC
boots. You can set this either on or off.
• Allow Shutdown/Reboot from stations: whether or not the stations are given
the option to shutdown or reboot the host PC. If disabled, then only the user on
the host machine can shutdown or reboot the host PC (provided that the logged-
in user on the host is an Administrator, Power Users or Backup Operators that
has been given the right to shut-down the system as configured in your user
policies). You may use Windows user profiles to only allow an administrator on
the host machine to shutdown or reboot the PC.
• Allow system shutdown only when one user is logged in: whether or not it is
required that there is one and only one user logged on for the system to be shut
down or rebooted. You can set this either on or off.
To Next Page
Loading...
