Non-Scale 2-Bag Bagwell Upgrade 29
2. On the front and back of the Bagwell, do the following:
Note: The front and back skirt panels of the Bagwell must be installed after the side
skirt panel of the Bagwell.
a. Attach the front and back skirt panels to the skirt brackets by aligning the open
slots of both skirt panels with the screw holes in the skirt bracket.
b. Secure both skirt panels to the bracket using eight (8) screws.
c. Adjust the skirt panel so that it is flush with the floor.
d. Tighten the screws to secure the skirt in place.
To Next Page
Loading...
