The state of charge (SoC) of both connected batteries
is immediately visible on top of the device thanks to the
two multicolored LEDs.
The system works with a 12V nominal voltage and it is
possible to connect two photovoltaic panels, on
separate inputs, with a maximum power of 180Wp
(depending on the model).
The Dip Switch selector, located next to the power
connections, allows you to select the output charge curve
in a simple and fast way.
The touch screen display DT002 (optional) with new
management software, allows you to view the charge
information and set the various settings with the new
communication protocol NDS.
MAIN FEATURES
• MPPT technology (+25% performances)
• Charging curve selection: GEL, AGM, Wet, and
LiFePO
4
• New Firmware OPTICHARGE
• Up to 6 charging phases
• Starting battery charge
• Desulphation curve
• Independent inputs for 2 solar panels
• SoC Quick view with status LEDs
• Touch screen Display (Optional)
To Next Page
Loading...
Need help?
General
