10
Connecting DOOR to Portable Receiver TREX
To program a TREX to receive alarms from DOOR, perform the
following steps:
1. Choose Programming and then Add transmitter from the menu
in the TREX.
2. Open the door that the door alarm is mounted on.
3. The LED on DOOR lights up with a steady red light to indicate
that the radio code is transmitted. The TREX beeps to indicate
that a radio code is received.
4. Choose an alarm text, an alarm number and the equipment type
door alarm in the TREX.
Connecting DOOR to Home Care Phone NEO
Receiver position 5 in NEO is standard for door alarms. To program
alarms from DOOR into position 5 in NEO, perform the following
steps:
1. Press and hold the grey button on NEO while switching NEO on.
2. Wait until ve beeps are heard, then release the button.
3. Open the door that the door alarm is mounted on.
4. The LED on DOOR lights up with a steady red light to indicate
that the radio code is transmitted, then possibly turns green for
two seconds. The home care phone sounds to indicate that the
radio code from DOOR is stored.
Note: If the in passage delay is enabled, the LED rst blinks during ve seconds
before an alarm is transmitted.
To Next Page
Loading...