14
[Advanced Settings]
[Projection Mode]: Select a way of placing the
projector.
• [Auto]: Automatically detects whether the
projector is inverted. Automatically switch
between these options.
• [Front]: The device is located in front of the
projection surface.
• [Front Ceiling]: The device is hanging from
the ceiling in an upside-down position. The
image is rotated by 180 degrees.
• [Rear]: The device is located behind the
projection surface.
• [Rear Ceiling]: The device is hanging from
the ceiling in an upside-down position behind
the projection surface. The image is rotated
by 180 degrees and horizontally mirrored.
[Motion Settings]: Set a sensitivity level for the
G-sensor to trigger autofocus and auto keystone
correction.
[Keystone Calibration]: Recalibrate the projector
if keystone correction doesn’t work properly.
• [Smart Solutions]: Receive alerts when
issues are detected.
• [Projection Angle Alert]: Receive alerts
when issues are detected.
• [Fine Tuning Popup]: Receive a popup after
Auto Gridless Keystone Correction.
• [Nebula Smart Popup]: Receive prompts
when the projector status changes.
To Next Page
Loading...
