Nebula Capsule II - Remote Control Setup; Initial Device Setup

English
11
2.
Prepare the Remote Control
The remote control comes with two AAA batteries.
①
For first time use, slide to open the battery
compartment, and install two AAA batteries.
②
To replace the battery, unlock and open the battery
compartment, insert a new battery matching the
polarity (+/-) as indicated, and then close and lock the
battery compartment.
3.
Get Started
①
Fully charge the built-in battery before using for the first
time by using the provided cable and charger.
USB-C
②
Hold on the projector for 2 seconds to turn it on.
③
Angle the device towards a suitable projection surface or
wall.
④
To focus the image, slightly move the projector to
engage autofocus. Or you can press and hold for 3
seconds to manually adjust the focus.
⑤
For first time use, follow the on-screen instructions to
complete the basic setup.
T
To give your Nebula Capsule II the fastest, safest
charge, use the supplied charger only.