NEC DT410 Series - Voice Call

133
STEP 5: Dial the desired number.
STEP 6: If an “Authorization Code” is required, the
caller hears a special dial tone.
STEP 7: Enter “Authorization Code”, or call will be de-
nied.
To Enter With Account Code (see above)
Service set tone is optional depending upon system
programming.
VOICE CALL
STEP 1: Lift the handset.
STEP 2: Dial the desired station number.
STEP 3: Press the Voice key.
STEP 4: Speak to called party.
Using Soft Key
STEP 1: Lift the handset.
STEP 2: Dial the desired station number; the VOICE
soft key appears while the station is ringing.
STEP 3: Press the VOICE soft key and speak to called
party.
Note:
This option is available only if system is pro-
grammed with Least Cost Routing.
Note:
If a 4, 8, 16 or 32-button display terminal is used,
the display indicates all of the digits dialed.
DT830
DT430/410
VOICE 2000
1:25 PM MON 11 MAY 2015
Note:
A Voice Call may be programmed on a One-
Touch Speed Calling key by pressing the One-
Touch Speed Calling key, dialing the extension,
and pressing the key. (The VOICE key
will display on LCD if it is programmed and saved
on the terminal.)
Note:
If called party is on their line when a Voice Call is
attempted, calling station's display indicates as
follows:
Note:
A voice call is restricted if called party's station is
not a DT Series. Display indicates as follows:
2000
Mic >>>Voice
1:25 PM MON 11 MAY 2015
Transfer
VOICE BUSY
1:25 PM MON 11 MAY 2015
VOICE REST
1:25 PM MON 11 MAY 2015