NEC DT410 Series - Page 194

185
STEP 18:The display goes back to the Edit screen.
Check the memory number assigned to the
directory data being edited.
STEP 19:If you need to assign a memory number man-
ually, select Memory ID on the screen of
the previous step, and then enter a desired
memory number (0 - 499).
Enter a memory number by using digits keys.
After entering the memory number, press
or OK soft key.
STEP 20:When the display goes back to the Edit
screen, press Save soft key to save the as-
signed data.
STEP 21:“The data is registered at memory number:
XX” is displayed. Press
key or OK soft
key. The display returns to the Directory
screen.
Note:
A memory number is automatically set in ascend-
ing numeric order.
1
2
[Edit]
3
4
5
OK
Back
6
7
8
9
0
Save
Gr
No
Ken Kobus
Tel #4
Tel #2
Tel #3
0
Colleagues
31300
NEC
Automatic
Automatic
0
Note:
If Name is not entered, “No Input Name” will
appear. Name information is required for a entry.
Note:
If a duplicate Memory ID is entered, “It will over-
write a data at memory number:XX” will appear. If
you do not overwrite the Memory ID, press Back
soft key. If you overwrite the Memory ID, press
or OK soft key.
Input a memory number.
[Memory ID]
OKBack
BK
1
0-499