18
Soft Key Features
When the soft key corresponding to a desired feature
name is operated, the selected feature name starts to
blink on the LCD. The blinking display of available
features takes precedence over the display of features
specified by the soft key pattern.
The following shows the default display patterns of
main features.
CF-Busy/FDB (Call Forwarding - Busy Line)
Permits a call to a busy station to be immediately
forwarded to a predesignated station.
CF-All/FDA (Call Forwarding - All Calls)
Permits all calls designated for a particular station to be
routed to another station regardless of the busy or idle
status of the called station.
CFLogout/FDL (Logged Out IP Station - Call
Destination)
Enables a system to transfer the call to appropriate
station when the terminal whose LOGGED OUT IP
STATION - CALL DESTINATION has already been
registered is in logout status.
Exe-Over/E-OVR (Executive Override)
Enables selected station users, upon encountering a
busy condition at an internal station, to bridge into the
busy connection.
CallWait/CW (Call Waiting)
Enables a busy station to receive a second incoming
call. A camp-on indication tone is sent to the busy
station, and you can use a switchhook flash to answer
the second call.
CallBack/CB (Call Back)
Provides the ability for a calling station to set a CALL
BACK. The calling station will be rung as soon as the
busy station becomes available.
Save&Rep/S&R (Save and Repeat)
Allows a station to save a specific dialed number and
then redial that number later.
Note:
The soft keys can be programmed in System
Data to blink, remain steady, have no indication,
or display a character when either in use or idle.
4:26 PM MON 11 MAY 2015
TRANSFER 2000
Mic >>>Conf.
BUSY
CONSULTATION HOLD
4:26 PM MON 11 MAY 2015
BUSY 2000
Mic >>>
CallBack
(1)
Push >>>
4:26 PM MON 11 MAY 2015
BUSY 2000
Save&Rep
>>>
CallWait
(2)
4:26 PM MON 11 MAY 2015
2000
Mic >>>NoDist
CONNECTION
To Next Page
Loading...
Need help?
General