NEC LCD Monitor

To Next Page

To Previous Page

(87/137)

Check code

BCC: Block Check Code

Refer to the section 4.5 “Check code” for a BCC calculation.

Delimiter

CR (0Dh): End of packet

Main Page

Default Chapter1
- Table of Contents1
- Application4
2 Connectors and Wiring5
- LAN Control5
- Preparation5
- RS-232C Remote Control5
- Communication Specification7
3 Communication Parameter7
- Communication Timing7
- LAN Control7
- RS-232C Remote Control7
4 Communication Format8
- Header Block Format (Fixed Length)9
- Message Block Format11
- Check Code13
- Delimiter14
5 Message Type15
- Get Current Parameter from a Monitor15
- Get Parameter" Reply16
- Set Parameter18
- Set Parameter" Reply19
- Commands20
- Control Commands23
6 Typical Procedure Example23
- How to Change the "Backlight" Setting23
  - How to Read the Measurement Value of the Built-In Temperature Sensors26
  - Operation Code (OP Code) Table29
7 Power Control Procedure42
- Power Status Read42
- Power Control44
8 Asset Data Read and Write46
- Asset Data Read Request and Reply46
- Asset Data Write48
9 Date & Time Read and Write50
- Date & Time Read50
- Date & Time Write52
10 Schedule Read and Write55
- Schedule Read55
- Schedule Write60
11 Self Diagnosis70
- Self-Diagnosis Status Read70
12 Serial No. & Model Name Read72
- Serial No. Read72
- Model Name Read73
13 Security Lock74
- Security Lock Control74
14 Direct TV Chanel Read & Write76
- Direct TV Chanel Read & Reply76
- Direct TV Chanel Write & Reply77
15 Daylight Saving Read & Write78
- Daylight Saving Read78
- Daylight Saving Write80
16 Firmware Version82
- Firmware Version Read82
17 Auto ID84
- Auto ID Execute84
- Auto ID Complete86
- Auto ID Reset88
18 Input Name89
- Input Name Read89
- Input Name Write91
- Input Name Reset93
19 Auto Tile Matrix95
- Auto Tile Matrix Execute95
- Auto Tile Matrix Complete97
- Auto Tile Matrix Monitors Read99
- Auto Tile Matrix Monitors Write101
- Auto Tile Matrix Reset103
20 Power Save Mode105
- Power Save Mode Read105
- Power Save Mode Write107
- Auto Power Save Time Read109
- Auto Power Save Time Write110
- Auto Standby Time Read112
- Auto Standby Time Write113
21 Setting Copy115
- Setting Copy Read115
- Setting Copy Write117
- Setting Copy Start119
22 Security Enable121
- Security Enable Read121
- Security Enable Write123
23 LAN MAC Address125
- LAN MAC Address Read125
24 Proof of Play127
- Start Proof of Play127
- Stop Proof of Play129
- Get Proof of Play Current131
- Get Proof of Play Total Number133
- Get Proof of Play Number to Number135

NEC LCD Monitor

Table of Contents

Related product manuals