English-14
Information
Provides information about the current resolution display (Main picture), current USB input setting and technical data
including the preset timing being used and the horizontal and vertical frequencies. Indicates the model and serial
numbers of your monitor.
OSD Warning
OSD Warning menus disappear with EXIT button.
NO SIGNAL: This function gives a warning when there is no Horizontal or Vertical Sync. After power is turned on or
when there is a change of input signal, the No Signal window will appear.
RESOLUTION NOTIFIER: This function warms if resolution other than the optimized resolution is used. After power is
turned on or when there is a change of input signal or the video signal doesn’t have proper resolution, the Resolution
Notifi er window will open. This function can be disabled in the MENU Tools.
OUT OF RANGE: This function gives a recommendation of the optimized resolution and refresh rate. After the power
is turned on or there is a change of input signal or if the video signal doesn’t have proper timing, the Out Of Range
menu will appear.
INTERLACED SIGNALS ARE NOT SUPPORTED: This function gives a warning when the interlace signal is used.
While the image is visible, change the signal of the device from interlaced to progressive (non-interlaced).
See “No Picture” in Troubleshooting for detailed information.
If you need detailed information about the controls, please use the ADVANCED OSD menu.
To Next Page
Loading...
Need help?
General
