NEC MultiSync E243F

English−18
Flexible Arm Installation
This monitor is designed for use with a flexible arm. Contact NEC for more information.
Follow the instructions provided by the manufacturer of the display mount. Remove the monitor stand before mounting.
WARNING: Please refer to “WARNING 8”. See the Specifications on page 27 for details.
Remove the Monitor Stand for Mounting
NOTE: • Handle with care when removing the monitor stand.
• Please securely hold the monitor stand while removing the screws to prevent the monitor stand from falling.
• Use only VESA-compatible alternative mounting method.
1 2 3
Non-abrasive surface
Mount the Flexible Arm
Using four screws that meet the specifications listed below, attach the arm to the monitor.
100 mm
100 mm
Mounting
Bracket
(2.0 - 3.2 mm)
Screw (M4)
Lock washer
and flat washer
Unit
8 - 10 mm
Thickness of
bracket and
washer
M4
4 x 12 mm with lock
washer and flat washer
10 mm
WARNING: Please refer to “WARNING 8”.