NEC MultiSync E245WMi - Contents; Quick Start

English-6
Contents
Your new NEC LCD monitor box* should contain the following:
Setup Manual Audio Cable*
3
Base Stand LCD monitor
(Base Stand not connected)
Setup
Manual
DVI-D to DVI-D
cable *
3
Mini D-SUB 15 pin to
Mini D-SUB 15 pin
*
3
DisplayPort cable*
2
Screws*
2
VESA plate*
2
Power Cord*
1
• LCDmonitorwithtiltbase
• PowerCord*
1
• VideoSignalCable(15-pinminiD-SUBmaleto15-pinminiD-SUBmale)*
3
• VideoSignalCable(DVI-DtoDVI-Dcable)*
3
• Video Signal Cable (DisplayPort cable)*
2
• SetupManual
• BaseStand
• Audiocable*
3
• VESA plate*
2
• Screws*
2
* Remember to save your original box and packing material to transport or ship the monitor.
*
1
Type of power cord included will depend on the where the LCD monitor is to be shipped.
*
2
US only.
*
3
Europe only.
The model name is on the label.
Label
Quick Start
To attach the Base to the LCD stand:
1. Place monitor face down on a non-abrasive surface (Figure 1).
NOTE: Handle with care when monitor facing down, for avoiding damage to the front control keys.
2. Please pivot base 90 degrees as shown in Figure 1.
NOTE: Handle with care when pulling the stand.
3. Attach the base stand to LCD monitor and properly lock screw of base stand bottom (Figure 2).
NOTE: Reverse this procedure if you need to re-pack the monitor.
Figure 1 Figure 2
Screw