NEC MultiSync EA271Q - Page 12

English-10
Mount Flexible Arm
This LCD monitor is designed for use with a flexible arm.
1. Follow the instructions in how to
Remove Monitor Stand for Mounting.
2. Using 4 screws that meet the specifications listed below, attach the arm to the monitor (Figure F.1).
Figure F.1
100 mm
100 mm
Thickness of Bracket (Arm)
2.0~3.2 mm
12 mm
Spring washer
Flat washer
CAUTION:฀฀•฀Only฀use฀4฀M4฀sized฀screws฀when฀mounting฀to฀avoid฀damage฀to฀the฀monitor฀and฀stand.฀
•฀To฀fulll฀the฀safety฀requirements,฀the฀monitor฀must฀be฀mounted฀to฀an฀arm,฀which฀guaranties฀the฀necessary฀
stability under consideration for the weight of the monitor. The LCD monitor should only be used with an
approved arm (e.g. TUEV GS mark).
•฀Tighten฀all฀screws฀(recommended฀Fasten฀Force:฀98฀-฀137N•cm).
A loose screw may cause the monitor to fall off the arm.
•฀Attaching฀the฀exible฀arm฀should฀be฀done฀by฀two฀or฀more฀people฀if฀the฀monitor฀cannot฀be฀placed฀face฀down฀on
a flat surface for installation.