33
Specifi cations
LCD Module Diagonal: 19,0 inch Active matrix; thin fi lm transistor (TFT)
Viewable Image Size: 19,0 inch liquid crystal display(LCD); 0.294 mm dot
Native Resolution (Pixel Count): 1280x1024 pitch; 270cd/m
2
white luminance; XtraView+™
technology; 600:1 contrast ratio, typical
Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Digital Input: DVI
Sync: Separate sync. TTL Level Positive/Negative
Composite sync. Positive/Negative
Sync on Green (Video 0.7Vp-p and Sync Negative 0.3V p-p)
Display Colors 16,777,216 Dependant on display card used.
Synchronization Horizontal: 31.5 kHz to 81.1 kHz Automatically
Range Vertical: 50.0 Hz to 85.0 Hz Automatically
Viewing Angle Left/Right: ± 89˚ (CR>10)
Up/Down: ± 89˚ (CR>10)
Image Formation Time 18ms (Typ.) 9ms (Gray to Gray Typ)
Resolutions Supported 720 x 400*1 at 70 Hz to 85 Hz Some systems may not support
640 x 480*1 at 60 Hz to 85 Hz all modes listed.
800 x 600*1 at 56 Hz to 85 Hz
832 x 624*1 at 75 Hz
1024 x 768*1 at 60 Hz to 85 Hz
1152 x 864*1 at 70 Hz to 85 Hz
1152 x 870*1 at 75 Hz NEC DISPLAY SOLUTIONS cites
1280 x 960 *1 at 60 Hz recommended resolution at 60Hz for optimal
1280 x 1024 at 60 Hz to 75 Hz.................. display performance.
1024 x 1280 *1 at 60 Hz
Active Display Area Landscape : Horiz. : 376 mm/14.8 inches
Vert. : 301 mm/11.9 inches
Portrait : Horiz. : 301 mm/11.9 inches
Vert. : 376 mm/14.8 inches
Power Supply 100 - 240 V ~ 50/60 Hz
Current Rating 0.63 – 0.27A (with option)
Dimensions Landscape: 402.3 mm (W) x 410.7-560.7 mm (H) x 247.3 mm (D)
15.8 inches (W) x 14.4 - 19.5 inches (H) x 9.7 inches (D)
Portrait: 330.3 mm (W) x 446.7 - 596.7 mm (H) x 247.3 mm (D)
13.0 inches (W) x 16.9 - 21.0 inches (H) x 9.7 inches (D)
Height Adjustment: 150 mm / 5.9 inches (Landscape)
Weight 9.0 kg
19.8 lbs
Environmental Considerations
Operating Temperature: 5°C to 35°C/41°F to 95°F
Humidity: 30% to 80%
Altitude: 0 to 10,000 Feet
Storage Temperature: -10°C to 60°C/14°F to 140°F
Humidity: 10% to 85%
Altitude: 0 to 40,000 Feet
*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different.
This is normal and necessary for all current fl at panel technologies when displaying non-native resolutions full screen. In fl at panel technolo-
gies, each dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.
NOTE: Technical specifi cations are subject to change without notice.
Monitor MultiSync
®
Specifi cations LCD1990SXi Notes
To Next Page
Loading...
Need help?
General