6
11. Hold all cables firmly against the stand. Place the cable cover
back onto the stand (Figure 13).
12. Connect the power cord to the power outlet (Figure 14).
NOTE: If using this monitor at AC125-240V, please refer to
Recommended Use section of this manual for proper selection of
power cord.
13. Turn on the monitor using the front power button and turn on the
computer.
14. Analog input only: No-Touch Auto Adjust automatically adjusts
the monitor to optimal settings upon initial setup for most timings.
For further adjustments, use the following OSM
®
controls:
• Auto Adjust Contrast • Auto Adjust
Refer to the Controls section of this User ’s Manual for a full
description of these OSM controls.
NOTE: For download information on the Windows
®
INF file visit
www.necdisplay.com.
NOTE: If you have any problems, please refer to the Troubleshooting
section of this User’s Manual.
Figure 14
Power Button
Display Setup - continued
Figure 13
To Next Page
Loading...
Need help?
General